40 x 48 StakCap TOPCAP
The ORBIS 40 x 48 StakCap Top Cap allows double stacking of stackable and rackable pallet loads. It is designed to secure 40″ x 48″ pallet loads for easier and more efficient material handling while enhancing the safety and maneuverability of double-stacked pallets. Plastic reusable top caps secure container loads to maintain uniform weight distribution and stability when in storage or transit. When the new 40″ x 48″ StakCap is combined with the ORBIS 40″ x 48″ StackR or Heavy-Duty Structo-Cell (HDSC) Pallets, economic and efficient unit loads are created. With the StakCap, pallet loads can be securely double-stacked for greater cube utilization and increased floor space in plants and trailers. Its low-profile design allows for a high nesting ratio, creating more floor space on plant, storage, and trailer floors. The 40″ x 48″ StakCap is a single-sheet thermoformed (HMWPE) top cap. The geometry of the StakCap allows the top cap to be used with ORBIS 24″ x 20″ and 24″x 16″ totes. The StakCap can be fully recycled at the end of its service life.
- Load stability by interlocking with legs of the ORBIS 40 x 48 StackR and HDSC pallets
- Full cleanability, with 100% draining capabilities
- Easy and secure strapping with molded-in channels for banding
- Low profile design enables a high nesting ratio in storage
Specifications
| Outside Length In | 49.9 |
| Outside Width In | 41.9 |
| Height In | 3.2 |
| Weight Lb | 14 |
| Truckload Qty 53ft Trailer | 1800 |
Vinyl Labels
Vinyl Labels are flexible plastic labels with adhesive backing that affix securely to your pallet. These long lasting labels are for use on all ORBIS thermoformed (HMWPE) pallets. Availability, requirement, and location for the vinyl labels can vary for each pallet. *Special vinyl labels are now available for some structural foam pallets. Please contact ORBIS for details.
ID Plates
Identification Plates are rigid plastic plates with adhesive backing that affix securely to your pallet. These plates are designed for durability and a long service life. Availability, requirement, and location of the identification plates can vary for each pallet.
Molded-In Logo
Molded-In Logo identification is a type of permanent identification that is molded into product. Original artwork must be supplied to ORBIS at the time of the order. Availability, requirement, and location for the molded-in identification can vary for each product.
Top Cap Hot Stamp
Hot Stamp identification is available for a wide variety of ORBIS top caps The original artwork must be supplied to ORBIS at the time of the order. Size, feasibility and available location of the hot stamp will vary for each top cap. Minimum shipment is required.